However turned to FreeBSD again .... see other thread / On 25/12/2007, ervin <[EMAIL PROTECTED]> wrote: > here http://www.ultradesic.com/?section=52 ... I did it & it > works ... :-) > > On 25/12/2007, Holger Rodriguez <[EMAIL PROTECTED]> wrote: > > Hi all, > > currently I'm running two net4501 devices with OpenBSD 4.0 as an choke > > and access router, and its running fine. > > Unfortunately the only machine providing an OpenBSD 4.0 environment, > > where the CF cards can be generated, is dying, and the only reason for > > this machine was the net4501's. > > > > The rest of the network are Debian/Etch machines (AMD-64 and Intel). > > Therefore I want the OS of the net4501 to change to Debian/Etch. > > > > I searched through the mailing list archive, but what I found was not > > (at least not for me) enough. > > I know, that using a Debian/Etch AMD-64 environment to create the > > net4501 installation > > needs at least > > - debootstrap > > - cross compile for the target > > I'm not afraid setting this up, but currently I feel very lost...... > > > > Therefore I dare to ask the question: > > Is there anybody out there, using a Debian/Etch installation (cross > > compile not necessary) to create the images for the net4501 devices? > > > > Any hints, like: > > - this is what you need > > - this is the CONFIG (for compiling the kernel) spec you want > > - these are the points to be aware of > > - are the devices supported in the standard kernel > > - etc. > > would be highly appreciated. > > > > (Next year I want to buy a n5501 with a lan1641, any problems I should > > know of in advance?) > > > > Thanks a lot in advance, > > Holger > > _______________________________________________ > > Soekris-tech mailing list > > [email protected] > > http://lists.soekris.com/mailman/listinfo/soekris-tech > > > > > -- > > > mvh/best regards ervin >
-- mvh/best regards ervin _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
