>>> wctdm24xxp0: ERROR: Unable to service card within 30 ms and unable to >>> further increase latency. >> >> Are you sure this is an IRQ conflict? When I have seen problems like >> this, it is usually a hardware issue with the card. This is a >> fascinating card, but it appears to use quite a bit of power. is the >> auxiliary power connector attached? Can you use a voltmeter to check >> the supply voltages on the card? See if you get different results with >> the module boards unplugged. Have you plugged it into a standard PC to >> see what happens there? > > The aux power connector should only be required if FXS modules are used. > If this card won't work for you, I can highly recommend the Rhino 8 > port card. I have several of these in production on net5501's. I also > have a net5501 with a Rhino 24 port card installed. I am using a 5a > non-soekris supplied power supply (12v) to power the net5501. >
Thanks for your advice Certainly it's not a power supply. Voltmeter shows stable 12V on the board and 3.3V on the card. The card behaves the same way with or without the modules. "Standard PC" test: everything is fine, no errors. Tried net-5501+TDM400 and didn't find any error message / IRQ Misses. >> Are you sure this is an IRQ conflict? No I'm not .. But how to interpret "IRQ misses", "Missed interrupt" messages otherwise ? I forgot to mention that zaptel-1.4.7 with debug=1 generates tons of "Abnormal interrupt 0001c0d4 detected" message and just paralyzes the system. Is there any known way to disable Geode LX AES Security Block that is using same IRQ ?? Next I'm going to try the Rhino card, Darrick. Thanks! Kiryushka _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
