Thank you for the link, Alexander! But: Are the sensors wired and scaled the same way in net5501 and net4801?
Most voltage readings seem OK, but I wonder about Volt 6 GND 222 2.624 V scale 1.0 2.624 V +/- 0.0118 V How can the ground level be 2.62 volts? I am currently operating the net5501 mounted on the standard case bottom, but without the top mounted, in 20-21 degrees room temperature. After leaving the net5501 powered-off for 7 hours, running env4801 immediatley after boot gives: Temp 2 (status=0x81) 38 C Could the temp really rise to 38 deg C in about one minute (from power-on to env4801 run)? After 30 minutes with no load at all, the temp has risen to 49 deg C and seems to stay stable at 49-52 deg C. Does this seem reasonable? During a three hour kernel compilation, the temperature seems keep stable at 49-52 deg C. Does it seem reasonable that such a mis-use does not lead to increased temperature? /Henrik Alexander wrote: > Try /usr/ports/sysutils/env4801 > > ----- Message from [email protected] --------- > >> Dear all, >> >> According to http://soekris.com/net5501.htm the net5501 has >> - Temperature and voltage monitor >> - Hardware watchdog >> >> Does anyone know how to read those under FreeBSD 8 ? >> >> [...] _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
