I have build a sdr(rx and tx) beased on the sdr1000. (On 80meters i
made different QSO's; i did build only the BPF for 80meters... the
other bands will follow)
Is there a program which can check the I an Q signal which are going
to the the soundcard; checking the phase and the amplitude?
When using the rx mode i disconnect for example one of the signals(I)
without any problem; the demodulation of the signal is still oke but
disconnecting the other signal (Q) the signal is gone.
Is it possible to see in SDRadio is the radio is using the I And Q or
only one of the signals?
73 Johan PA3GSB
SPONSORED LINKS
| Ham radio | Craft hobby | Hobby and craft supply |
YAHOO! GROUPS LINKS
- Visit your group "soft_radio" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
