Hi Szabolcs, I'm not sure to understand correctly, but it looks like you need something similar to a "Bridge Polygons", but with the ability to add some cross sections evenly spaced along the bridge right ?
I made a little prototype using ICE modeling : picture<http://dl.dropbox.com/u/5533643/Softimage/BridgeExtrusion.jpg> <http://dl.dropbox.com/u/5533643/Softimage/BridgeExtrusion.jpg>and sample scene <http://dl.dropbox.com/u/5533643/Softimage/BridgeExtrusion.scn>. It was just an excuse to play with ICE ;-), but maybe it will help or give you some ideas. Cheers Guillaume Laforge On Tue, May 29, 2012 at 7:51 AM, Szabolcs Matefy <[email protected]>wrote: > ** ** > > Hey folks,**** > > ** ** > > Does anybody know, if there is solution to the following issue. I have a > minigun and an ammo backpack. I have to make the ammo belt. I have to make > sure, that the beginning and the ending cross-section fits into the slots. > Technically I want to make sure, that the extrusion starts from a given > profile and ends in a given profile without any roll and so on that used > the happen in XSI.**** > > ** ** > > Huh**** > > ** ** > > ** ** > > Cheers**** > > ** ** > > > Szabolcs **** > ___ > This message contains confidential information and is intended only for > the individual named. If you are not the named addressee you should not > disseminate, distribute or copy this e-mail. Please notify the sender > immediately by e-mail if you have received this e-mail by mistake and > delete this e-mail from your system. E-mail transmission cannot be > guaranteed to be secure or error-free as information could be intercepted, > corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. > The sender therefore does not accept liability for any errors or omissions > in the contents of this message, which arise as a result of e-mail > transmission. If verification is required please request a hard-copy > version. Crytek GmbH - http://www.crytek.com - Grüneburgweg 16-18, 60322 > Frankfurt - HRB77322 Amtsgericht Frankfurt a. Main- UST IdentNr.: > DE20432461 - Geschaeftsfuehrer: Avni Yerli, Cevat Yerli, Faruk Yerli >
