I love to read people doing support for gear :) Thanks Will !
On 19 September 2014 14:10, Will Sharkey <[email protected]> wrote: > Child comp is usually fine. Just be careful not to break an arm plane or > leg plane (ie, only move a knee guide local to the leg bone length, > otherwise, rotate the leg joint to fit the guide.). My Softimage is > rendering otherwise I'd tell you the exact axis to move on, probably X > axis. > > If you delete a control curve in the controllers grp of the guide, gear > will make nice new default ones on generation. That should clean up your > controls. Or make a curve to desired shape, rename it to a controller in > the controllers grp, delete the original - Then gear should use that one. > > On Fri, Sep 19, 2014 at 4:40 PM, Sebastien Sterling < > [email protected]> wrote: > >> Hey again guy's, yet another quick gear question. >> >> is using child comp while setting up the guide a big nono ? >> >> my knees ik CTRL keep spawning of center >> >> also hand seem to spawn a little further down then they should >> >> >> >> On 17 September 2014 16:51, Emilio Hernandez <[email protected]> wrote: >> >>> No prob Sebastien. >>> >>> Specifically I am using 2.7.3. But as Eric said, any 2.7.x works fine >>> with Gear. >>> >>> Cheers! >>> >>> ------------------------------------------------------- >>> Emilio Hernández VFX & 3D animation. >>> >>> 2014-09-17 9:55 GMT-05:00 Eric Thivierge <[email protected]>: >>> >>> Shouldn't matter 2.7.X version should be fine. >>>> >>>> On Wednesday, September 17, 2014 10:48:10 AM, Sebastien Sterling wrote: >>>> >>>>> Thx Emilio, would that be 2.7.0 ? >>>>> >>>>> On 17 September 2014 15:35, Emilio Hernandez <[email protected] >>>>> <mailto:[email protected]>> wrote: >>>>> >>>>> I am using Python 2.7 and it works fine. >>>>> >>>>> Cheers! >>>>> >>>>> >>>>> >>>>> ------------------------------------------------------- >>>>> Emilio Hernández VFX & 3D animation. >>>>> >>>>> 2014-09-17 9:32 GMT-05:00 Sebastien Sterling >>>>> <[email protected] <mailto:[email protected] >>>>> >>: >>>>> >>>>> hey everyone >>>>> >>>>> Am trying to set up Gear_mc on an old PC that doesn't have >>>>> python installed as a default. >>>>> >>>>> i was just wondering which version do i need to install, as i >>>>> seem to remember that not just any version will do. >>>>> >>>>> Thank you for indulging my noobery. >>>>> >>>>> All the best S.Sterling >>>>> >>>>> >>>>> >>>>> >>>> >>> >> >
