Hey group,
I've got an older 6.1-Lite that I've been fussing with on 30M with
CW Skimmer.
I'd had it up a few hours when someone notified me my spots were
off. I started looking more closely (and I hadn't noticed it in
Rocky) that I was seeing mirror signals on either side of the center...
I've just now had time to investigate further and:
On the Audio side, I have signal on both L/R-T/R. If I go to the
center of the board and look for the square waves, I see them at about
90 out of phase, but they are rather ugly looking square waves.
Just jumping back and forth in Skimmer, I find that the "correct"
signal is a bit louder than the image, but, both are enough for
skimmer to pickup.
What is the correct Q/I relationship< Q=Right, I=Left, or the other
way around?
I've got T/R correctly connected going out to the PC, but: Skimmer
settings are are Q=Left I=Right in order to see things where I think
they should be (eg: stronger sig on the low side of the center; as
confirmed with my big rig).
Anyone have any ideas where I should look?
73,
Joe, KC0VKN
