With the W6DHW board and a CMOS SI570, insert the signal between JP1 pin 2 & 4
for /4 operation and leave the JP2 crystal jumpers off.
radionewfie <[EMAIL PROTECTED]> wrote:
I'm trying to interface the W6DHW board to my RXTX 6.2 kit and will try to use
the PE1NNZ
interface with the DB25 to control the "rig"
As I understand it, I have to connect three points of the Si570 board to 80 /
40 selection
"jumper" section of the RXTX board. (JP2) Is this correct?
Do I have to disable the crystals on the RX TX ? I think not if I want to Xmit
eh ?
I have the CMOS Si570... and also have the Xtall interface.
Any thoughts which would be the better route to go ?
Any advice is appreciated.
BJ Mercer
VE3ZLB
Sudbury, ON
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
