I'm trying to interface the W6DHW board to my RXTX 6.2 kit and will try to use the PE1NNZ interface with the DB25 to control the "rig"
As I understand it, I have to connect three points of the Si570 board to 80 / 40 selection "jumper" section of the RXTX board. (JP2) Is this correct? Do I have to disable the crystals on the RX TX ? I think not if I want to Xmit eh ? I have the CMOS Si570... and also have the Xtall interface. Any thoughts which would be the better route to go ? Any advice is appreciated. BJ Mercer VE3ZLB Sudbury, ON
