On the XTALL interface to RXTX board drawing I have added the two
jumpers in lieu of R54 & R60. However R58 & R59 are mounted
vertically not horizontally as stated on drawing. I also need to
change them out to the stated value of 10K rather than the kit value
of 1K & 22.1K. I have also added the jumper wire from the base of Q14
and routed it up through the via between x4 & x8 near J1 but have not
yet soldered it into the via.
Before I replace R58, R59, and solder the jumper to the via does this
all sound right before I commit?
Thanks in advance.
Mike
N5RWH
