I got that same error until I loaded the most recent Firmware. Then it worked. Sounds like your close.
-Curtis -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Ian McBride Sent: Thursday, June 06, 2002 4:49 PM To: '[EMAIL PROTECTED]' Subject: RE: [SonicWALL]- Mutliple LAN subnets behing SW Pro Ok, got this figured out...it was a provider issue (imagine that). One last question. I'm trying to put the machines in the second subnet in the DMZ. When I try to add the range, or even a single IP to the DMZ addresses section, I keep getting: The following parameter had problems: Add Range pair I've tried defining the range under Advanced -> Intranet and General -> Network but no luck. Ideas? -----Original Message----- From: Ian McBride [mailto:[EMAIL PROTECTED]] Sent: Thursday, June 06, 2002 12:03 PM To: '[EMAIL PROTECTED]' Subject: [SonicWALL]- Mutliple LAN subnets behing SW Pro I gave up on doing NAT for the LAN and DMZ because I couldn't get it configured without the Sonicwall locking up and having to hard reset it. Here's what I'm trying to do now: I've now got 2 public subnets routed to my Cisco 675...one's going to the eth0 interface and the other is going to the vip0 interface. One would like to think it would be as easy as adding the additional subnet under General -> Network, but apparently it's not. I tried to set up a static route as well but that didn't seem to work either. Does anyone have experience with a config like this and care to share their thoughts? Thanks as usual :) --- [This E-mail scanned for viruses by Declude/F-Prot AV] ============================================================================ ======================= To unsubscribe, send email to [EMAIL PROTECTED] In the body of the email put the following: unsubscribe sonicwall your_name The archive of this list is at http://www.mail-archive.com/sonicwall%40peake.com/ --- [This E-mail scanned for viruses by Declude/F-Prot AV] ============================================================================ ======================= To unsubscribe, send email to [EMAIL PROTECTED] In the body of the email put the following: unsubscribe sonicwall your_name The archive of this list is at http://www.mail-archive.com/sonicwall%40peake.com/ --- [This E-mail scanned for viruses by Declude/F-Prot AV] =================================================================================================== To unsubscribe, send email to [EMAIL PROTECTED] In the body of the email put the following: unsubscribe sonicwall your_name The archive of this list is at http://www.mail-archive.com/sonicwall%40peake.com/
