Bao, The "//" at the beginning of the paths doesn't look correct. I would think that it would start with a '/'.
-Joe On Thu, Aug 22, 2013 at 12:53 PM, <[email protected]> wrote: > Hello everyone, > > I've been using Mascot-based Analysis Pipeline. However, converting mascot > DAT file to pepXML turns in an error "UNC paths are not supported. > Defaulting to Window directory." The details are as follows: > > *EXECUTING: run_in // > artemis.umaryland.edu/data/users/btran/Window_TPP_test/DAT; > c:\Inetpub\tpp-bin\Mascot2XML // > artemis.umaryland.edu/data/users/btran/Window_TPP_test/DAT/F001507.dat-D// > artemis.umaryland.edu/data/users/btran/db/TB_uniport_070405.fasta-Etrypsin > * > > '\\artemis.umaryland.edu\data\users\btran\Window_TPP_test\DAT' > CMD.EXE was started with the above path as the current directory. > UNC paths are not supported. Defaulting to Windows directory. > filepath: //artemis.umaryland.edu/data/users/btran/Window_TPP_test/DAT/, > extn: F001507 > cannot create tgz file "// > artemis.umaryland.edu/data/users/btran/Window_TPP_test/DAT/F001507.tgz" > (error "Permission denied"), quitting > command "c:\Inetpub\tpp-bin\Mascot2XML // > artemis.umaryland.edu/data/users/btran/Window_TPP_test/DAT/F001507.dat-D// > artemis.umaryland.edu/data/users/btran/db/TB_uniport_070405.fasta-Etrypsin" > failed: Operation not permitted > > I tried to add the value DisableUNCHECK REG_DWORD (value set to 0x1) as > instructed by Microsoft (http://support.microsoft.com/kb/156276). > However, it doesn't work for my case. > Any supports or ideas you can provide helping me to solve this issue is > pretty much appreciated! > > Regards, > > Bao > > -- > You received this message because you are subscribed to the Google Groups > "spctools-discuss" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/spctools-discuss. > For more options, visit https://groups.google.com/groups/opt_out. > -- You received this message because you are subscribed to the Google Groups "spctools-discuss" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/spctools-discuss. For more options, visit https://groups.google.com/groups/opt_out.
