Hi Mike, Did you check if this is just a timeout? If it is, you may higher the timeout-limit and try again.
Regards, Christian Schneider Enterprise Service Specialist 4-tune GmbH Sägereistrasse 29 CH-8152 Glattbrugg http://www.4-tune.ch christian.schnei...@4-tune.ch Office ZH: +41 (0)44 818 02 03 Office SG: +41 (0)71 930 07 00 Mobile: +41 (0)79 418 4542 Fax: +41 (0)71 930 0701 On Jan 5, 2009, at 9:52 PM, Friedman, Mike wrote: > Also, I forgot to add we are running on Spectrum 9.0. > > > > Michael R. Friedman > > Network Engineer > > Network Engineering | Orbitz Worldwide > > > > > > From: Friedman, Mike > Sent: Monday, January 05, 2009 12:36 PM > To: 'spectrum@listserv.unc.edu' > Subject: NCM Error message > > > > Hello everyone, > > > > We have been getting the following error in OneClick when trying to > run a custom perl config to capture data from a couple of our > Juniper DX redline devices. > > “Unable to connect to the ncmservice. The ncmservice daemon may not > be running on the SPECTRUM host machine.” > > > > The unusual thing is our script will work on 7 out of our 10 redline > devices and only errors like this on 3 devices. Even more unusual > is the script worked fine on the 3 erring devices the first time it > ran, but once a config backup has done once on these devices I get > this error. > > > > Anyone have any ideas on what may be the problem? > > > > Thanks, > > > > Michael R. Friedman > > Network Engineer > > Network Engineering | Orbitz Worldwide > > > > > --To unsubscribe from spectrum, send email to lists...@unc.edu with > the body: unsubscribe spectrum christian.schnei...@4-tune.ch --- To unsubscribe from spectrum, send email to lists...@unc.edu with the body: unsubscribe spectrum arch...@mail-archive.com
