Hello David Hello List I have the similar problem with the BAD_LINK Detectet...
In the configuration of the VNM can you set the flag --> Fault isolation - Attr. "Port fault Correlation" to Management neighbors only therefore, the alarm should not occur because the device has not been discovered. But with this config, i still receive the error BAD_LINK Detectet (e.g. by Workstation) This behavior is limited to a few routers. Has someone also this problem or has someone a solution? Many thanks in advance -- Matthias Kägi Enterprise Service Specialist 4-tune GmbH Sägereistrasse 29 CH-8152 Glattbrugg http://www.4-tune.ch [email protected] Office ZH: +41 (0)44 818 02 03 Office SG: +41 (0)71 930 07 00 Mobile: +41 (0)79 7670808 Fax: +41 (0)71 930 0701 Am 21.10.2009 um 10:33 schrieb David Game: > They were “down” when the device was discovered. Spectrum sets the > status of each port as normal as it is initially discovered. If the > link goes to “up” afterwards it’s still classified as “Normal” but > (and I will need this clarified) the link condition will then go > critical if it goes down again > > Dave. > > From: Michael Harris [mailto:[email protected]] > Sent: 20 October 2009 19:12 > To: spectrum > Subject: [spectrum] BAD_LINK Detected > > Hello list. Simple question and I should probably know this…I’m > more of system guy than network guy. > > In the screenshot you see a list of interfaces, with various status/ > conditions. What I need to understand is why I have a Critical and > therefore a BAD_LINK DETECTED alarm on the first interface…and not > on the other 3 interfaces with a down status. I see this on a > number of devices. > > Thanks, > Mike > > <image001.jpg> > > > __________ Information from ESET Smart Security, version of virus > signature database 4527 (20091020) __________ > > The message was checked by ESET Smart Security. > > http://www.eset.com > --To unsubscribe from spectrum, send email to [email protected] with > the body: unsubscribe spectrum [email protected] > > ______________________________________________________________________ > This email has been scanned by the MessageLabs Email Security System. > For more information please visit http://www.messagelabs.com/email > ______________________________________________________________________ --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
