Hello,
Recently I've started to work on a OneClick subview to show FDB table for our switches. I know there is an "out-of-the-box" subview "Transparent Bridge ..." which handles the FDB but, for some reason it shows only on a handful of switches. Everything went OK until I've seen the result: the MAC address is displayed in decimal instead of hex. MIB Tools shows a normal format (hex) for OID's involved in FBD but the table is messed up. Here is how it looks: I've been reading OneClick Customization and tried to figure out an expression able to convert this from d3ecimal to hex ... no success so far. What can I do to have a proper MAC format displayed in there? Thank you, Regards Eugen NAIMAN CONFIDENTIALITY NOTICE AND DISCLAIMER The information in this transmission may be confidential and/or protected by legal professional privilege, and is intended only for the person or persons to whom it is addressed. If you are not such a person, you are warned that any disclosure, copying or dissemination of the information is unauthorised. If you have received the transmission in error, please immediately contact this office by telephone, fax or email, to inform us of the error and to enable arrangements to be made for the destruction of the transmission, or its return at our cost. No liability is accepted for any unauthorised use of the information contained in this transmission. If the transmission contains advice, the advice is based on instructions in relation to, and is provided to the addressee in connection with, the matter mentioned above. Responsibility is not accepted for reliance upon it by any other person or for any other purpose. --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
<<image001.jpg>>
