Thanks Ok. :) That's what I needed, someone to tell me not to give up! All working now...at last. Although I get some CRC errors, think this was covered on the list archive (?) - will check.
thanks again Martin ----- Original Message ----- From: "Ok zelf" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Saturday, February 15, 2003 5:36 AM Subject: [speedtouch] Re: St330 with BT (UK) and Mandrake 9.0 > Martin Howitt wrote: > > >Hi all. > > > >hopefully someone on this list can help me....apologies if this has been > >covered before, the list archive doesn't seem to contain this specific thing > >though. :( > > > >I've just done a fresh install of Mandrake 9.0, having bought a new > >SpeedTouch 330 USB/ADSL modem, and downloaded the > >speedtouch-1.2-beta1 drivers from Sourceforge. Using the windows-supplied > >alcaudsl.sys microcode I seem to have managed to get modem_run to load ok > >and pppd also seems to load, only I don't get any IP bound to the interface > >(doesn't appear in ifconfig). > >I have tried the patch that Tim Woodall posted on this list a while back, it > >didn't seem to make any difference (and I'm not sure if I needed it with the > >latest tarball?) > > > >a tail of the syslog shows the following lines: > > > >Feb 14 18:36:35 localhost modem_run[2391]: modem_run version 1.2-beta1 > >started by root uid 0 > >Feb 14 18:36:37 localhost kernel: usb_control/bulk_msg: timeout > >Feb 14 18:36:37 localhost kernel: usbdevfs: USBDEVFS_BULK failed dev 2 ep > >0x85 len 512 ret -110 > >Feb 14 18:36:54 localhost modem_run[2391]: ADSL synchronization has been > >obtained > >Feb 14 18:36:54 localhost modem_run[2391]: ADSL line is up (576 kbit/s down > >| 288 kbit/s up) > >Feb 14 18:36:54 localhost kernel: CSLIP: code copyright 1989 Regents of the > >University of California > >Feb 14 18:36:54 localhost kernel: PPP generic driver version 2.4.2 > >Feb 14 18:36:54 localhost pppd[2397]: pppd 2.4.1 started by root, uid 0 > >Feb 14 18:36:54 localhost pppoa3[2398]: pppoa3 version 1.2-beta1 started by > >root (uid 0) > >Feb 14 18:36:54 localhost pppoa3[2398]: Control thread ready > >Feb 14 18:36:54 localhost pppd[2397]: Using interface ppp0 > >Feb 14 18:36:54 localhost pppd[2397]: Connect: ppp0 <--> /dev/pts/1 > >Feb 14 18:36:54 localhost kernel: HDLC line discipline: version $Revision: > >3.3 $, maxframe=4096 > >Feb 14 18:36:54 localhost kernel: N_HDLC line discipline registered. > >Feb 14 18:36:54 localhost pppoa3[2409]: host --> pppoa3 --> modem stream > >ready > >Feb 14 18:36:54 localhost pppoa3[2410]: modem --> pppoa3 --> host stream > >ready > >Feb 14 18:36:54 localhost /etc/hotplug/net.agent: assuming ppp0 is already > >up > > > >I feel I am getting close, but perhaps I've made an obvious mistake? Any > >pointers would be appreciated. Clearly I'm no Linux expert :( > > > >thanks in advance > >Martin > > > >[EMAIL PROTECTED] > > > > > > > >Liste de diffusion modem ALCATEL SpeedTouch USB > >Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe > > > > > > > > > > > You're close.............check your settings in /etc/ppp/peers/adsl and > /etc/ppp/chap-/pap-secrets. > Look at the other mails in the archive..................they will help. > > Ok > > > > > Liste de diffusion modem ALCATEL SpeedTouch USB > Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe > > > Liste de diffusion modem ALCATEL SpeedTouch USB Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe
