I just dug back through my spreadsheet looking for where/who/what I bought to use on my dual HS4 installation. The only cable I could find I'd ever bought was a stock 1500 style cable. I even used the stock 'C' cable attachment piece from the ZS setup. It's visible in the second row of photos (right side) at http://www.teglerizer.com/triumphstuff/75w_carbswap.htm
Paul Tegler [EMAIL PROTECTED] www.teglerizer.com ----- Original Message ----- From: "Joe Curry" <[EMAIL PROTECTED]> To: "Chris Pappathopoulos" <[EMAIL PROTECTED]> Cc: "spitfire" <[EMAIL PROTECTED]> Sent: Sunday, March 16, 2003 6:25 PM Subject: Re: HS4 accelerator cable > Chris Pappathopoulos wrote: > > > > Is there a source in the states for an accelerator cable that will work > > with twin SU HS4s? Will a cable from an HS2 equipped car work, or is the > > linkage different between the two setups? The cable on the car with the > > Strombergs will not work becaase the cable sticks out too far past the > > outer covering. > > > > Thank you, > > Chris Pappathopoulos > > > Chris, > My question would be, "What car equipped with HS2's used a cable. All > the US ones had the rod that pushed the linkage between the carbs up > from below. > > That being the case, I fabricated a bell linkage from drawings in the > Haynes manual to create a place to mount a cable that was made for US > 1500's (single ZS). I had to clip the end off the cable and install a > different style of end so that I could adjust the cable. > > Joe /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
