OKIt started as a very simple job to remove the screws from the door latch assemblys in the door jams. As it turns out the < Phillips head screws were installed with a thread locking compound. I had to drill through the center of the screw and remove them with a screw extractor.
While doing the last one, the extractor broke flush in the hole. Now, I have to drill out the extractor, which is extremely hardened steel. I do not have a bit (in my tool box) that will begin to cut through this material. Would greatly appreciate any suggestions. Regards, Ed Hamilton *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
