See "the nut method" about halfway down this page: http://www.thebugshop.org/gotech.htm
M D "Doc" Nugent Renton, WA --- Ed Hamilton <[EMAIL PROTECTED]> wrote: > OKIt started as a very simple job to remove the > screws from the door latch > assemblys in the door jams. As it turns out the < > Phillips head screws > were installed with a thread locking compound. I > had to drill through the > center of the screw and remove them with a screw > extractor. > > While doing the last one, the extractor broke flush > in the hole. Now, I > have to drill out the extractor, which is extremely > hardened steel. I do > not have a bit (in my tool box) that will begin to > cut through this > material. > > Would greatly appreciate any suggestions. > > > > Regards, > > Ed Hamilton __________________________________ Yahoo! SiteBuilder - Free web site building tool. Try it! http://webhosting.yahoo.com/ps/sb/ *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
