If your car is sitting level (on the wheel or on blocks) simply measure up from the floor to the mount bolt on the rear mount of the bumper. Then match the dimension on the side, (from floor to rear mount bolt)
You probably can't use the body hole of the rear mount as the mount is not symmetrical. But the bolt hole of the bumper for the rear mount is the same position as the one on the side. If you really need it...let me know.... I'll measure my own '67 Spit I am just finishing up the resto of. I'll measure down from the top fender seam and forward from the rear edge, parallel to the bumper. You should be able to replicate the position accurately. Paul Tegler [EMAIL PROTECTED] www.teglerizer.com ----- Original Message ----- From: "James Carruthers" <[EMAIL PROTECTED]> To: "Spitlist" <[EMAIL PROTECTED]> Sent: Monday, January 26, 2004 12:23 PM Subject: Fitting Mk3 rear bumpers > Hi Listers, > > > I have got to drill new holes for my rear bumpers - I have the rear > holes - just not the ones on the sides. > > I don't trust myself to drill the holes in place "so they look" right - > there must be some accurate way of achieving this properly...? > > Any clever ideas? > > > James > > 69 Signal Red Spit *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
