The engine usually needs a jack (with wood block to protect) under the oil pan. I use the scissors one here. That leaves my hydraulic one free to sit under the tranny. Jack it up so that it just touches and you can use it to slide the tranny back and forward.
Yes two people help especially as you really can't lift easily under the dash (where bolts and trolley jack help). but you can do it on your own as I have done.
Alan
David Mayer wrote:
Hello all,
Now that the weather has cleared, i have pulled the spit into the garage to work on the transmission. I am replacing the clutch with a Borg & Beck unit. So tonight i loosened everything up so that it will be easier to take off later. I am removing the Transmission from inside the car. Now here is my question, do i need to prop something under the back end of the engine when i remove the trans.? So that the engine does not twist on the mounts?
Does anyone have any secrets to doing this procedure of taking the trans out from inside the car? I am assuming it will be easier with two people?
Thank you in advance, Dave '68 Spit...in bits again.
*** http://www.team.net/the-local ***
Your messages not reaching the list? Check out http://www.team.net/posting.html
*** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
