You don't need to remove your seats. Actually... having the passenger seat there, makes things a bit easier. Personally, when I pull mine, I'm seated in the passenger seat and the tranny ends up in my lap, before I get out of the car with it.
An easy trick.... before you even unbolt anything.... slip a tarp under the tranny and over the frame rails Place a jack under the oil pan at the rear (preferably with a block of wood against the pan) but not under the edge of the engine back plate or bellhousing lip. Disconnect the rear driveshaft bolts and tranny rear mount. Unbolt the bellhousing/engine bolts. Now jack the motor up about 1-2" which will raise the tail cone to clear the driveshaft coupling. Now just yank the whole tranny straight back to get the input shaft to clear the clutch. Let the bell housing drop onto the frame rails. Now since the tarp is laying in between the tranny and frame, you can literally 'drag' the tranny out by the tarp. This will also help keep grease and grime off the interior of the car. (kinda' like a giant diaper) It will also help stop the oil drian plug from catching on stuff as you try to pull the tranny out. You'll need to lift the tail cone to angle the bellhousing to get it out from under the edge of the dashboard. Before re-installing, make sure a stud or two is installed in the top holes. This will help align the tranny when trying to get it back in. Going back in, again... the tarp will help let you slip/move the tranny around to get it back into position., again keeping the interior grease free. My tarp...is one of those cheap blue plastic tarps, just folded over a few times. This is where a second person can REALLY help. Your helper can help position the front of the bellhousing to help get the input shaft back into the clutch. Get your helper to straddle the engine, standing on the tops of each wheel's a-arms. Use a piece of rope, looped around the bellhousing, and the ends of the rope passed up past the firewall, between the engine and firewall. Your helper can then pull on the rope to raise/lower the bellhousing while you lift the tail cone to get things lined up. Then lower the jack carefully to let the tranny rest back on its rear mount, Paul Tegler [EMAIL PROTECTED] www.teglerizer.com *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
