Richard: You may be thinking of a different type switch. This one is a rocker switch. I can get it to move up and down a bit but not out. I was thinking there must be some plastic tabs that expand when you push it into the hole, but I can't see them. I will give it another try with better light. I may need to remove the wood first, maybe that is what holds it in place. Dave
-----Original Message----- From: "Gosling, Richard B" <[EMAIL PROTECTED]> Sent: Jun 4, 2004 9:10 AM To: 'Dave Fain' <[EMAIL PROTECTED]>, [EMAIL PROTECTED] Subject: RE: removing hazard switch from GT6/Spitfire Dave, IIRC (and I might be wrong), you first need to remove the red knob, which simply unscrews. There is a metal tab sticking out of the housing of the switch, which is held onto the back of dash by a single screw. Remove this screw, and the switch can be pulled out of the rear of the dashboard. I hope you get it sorted! Richard Gosling This email and any attached files are confidential and copyright protected. If you are not the addressee, any dissemination of this communication is strictly prohibited. Unless otherwise expressly agreed in writing, nothing stated in this communication shall be legally binding. *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
