Hey Paul, I am in the same situation. I think the flinger distance from end of axle is important. The rest should be apiece of cake. http://www.ljvaughan.homestead.com/axlehub.html
Larry ----- Original Message ----- From: "Paul Grafelman" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, January 16, 2005 2:04 PM Subject: Hub to flange spacing > List, > > Re-assembling the rear-end on my 77 Spit. Can anyone tell me the correct > distance from the outside face of the flange to the outside face of the hub > once assembled? I am concerned that I installed the hubs too far onto the > shafts. That or the flanges are not far enough on-to the shafts. Either way > my drums are not fitting correctly. Also, anyone know a good way to torque > the flange nuts (124 ft lbs) with the shafts installed? *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
