When you de-arch the rear spring, will the spring rate change? I very much doubt it - the elasticity of the metal doesn't change, the amount of metal doesn't change, its layout doesn't change, the only thing that could change the spring rate would be if the shorter leaves were de-arched too much so that they weren't actually contributing anything, in which case the spring rate would become softer.
If you use a block, to lower the rear, will the geometry change? Not really, other than the change you get from the car being lower, the same change you get driving over a bump or putting a fat bloke in the passenger seat. The wheel must always remain perpendicular to the driveshaft, and the inner end of that is fixed to the diff, and the position of the diff hasn't changed. With the car lower the wheel will be further up into the wheelarch, and so camber inevitably changes a bit with a lowered car. In theory, with the neutral position being a bit higher in the car, the upright will be at a very slightly different angle, and that will have a tiny effect on the load vs. displacement of the wheel, but the effect of this will be too small to be measurable. If you redrill the rear vertical links, to lower the rear, will the geometry change? Ditto my above answer. Why would a kit to improve the reverse gear, laygear+1st/2nd hub+reverse idler gear, change 3rd gear? Is 155207 a British Leyland number? That is a close ratio 3rd gear. No idea!! Richard Gosling This email and any attached files are confidential and copyright protected. If you are not the addressee, any dissemination of this communication is strictly prohibited. Unless otherwise expressly agreed in writing, nothing stated in this communication shall be legally binding. *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
