I bought a couple of K&N filters for my 40DCOE carbs. APT recommended 45 DCOE filters for 40's with ramstacks / air horns. The backing plate holes allow the stack to be inserted but not seated. The collar will not go through the hole. Bummer. I just bought a nice drill press. Is there a bit or hole saw or anything I can use to take the holes from 1 3/4" to 1 7/8 " . I will probably get them off center if I freehand with a grinder. All recommendations appreciated. I will no longer comment on the value of freely offered opinions. Although, since this is my last chance to critique former opinions I must say that DCOE carbs will wear faster if run without air horns. I have one that is loose. The throttle body has a nice wear ring. The aux vent has a rounded base and a tight spring. I suspect it was ran without an airhorn and vibration did it's evil work. Nuff said.
Larry *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
