Larry Vaughan wrote:
I bought a couple of K&N filters for my 40DCOE carbs. APT recommended 45 DCOE
filters for 40's with ramstacks / air horns. The backing plate holes allow the
stack to be inserted but not seated. The collar will not go through the hole.
Bummer. I just bought a nice drill press. Is there a bit or hole saw or
anything I can use to take the holes from 1 3/4" to 1 7/8 " . I will probably
get them off center if I freehand with a grinder. All recommendations
appreciated. I will no longer comment on the value of freely offered opinions.
Although, since this is my last chance to critique former opinions I must say
that DCOE carbs will wear faster if run without air horns. I have one that is
loose. The throttle body has a nice wear ring. The aux vent has a rounded base
and a tight spring. I suspect it was ran without an airhorn and vibration did
it's evil work. Nuff said.
Well, critique away, Larry. No advice from me--it just seems to annoy
you further. :)
I suppose I'll just have to swallow my thirty years' experience running
and tuning these carbs for myself and others, throw my library of books
on these carburetors out the window, and defer to your determinedly
defended opinions, contrary to fact though those opinions may be. Good
luck with this very difficult task of mounting air horns.
Cheers.
--
Michael D. Porter
Roswell, NM
Never let anyone drive you crazy when you know it's within walking distance....
*** http://www.team.net/the-local ***
Your messages not reaching the list?
Check out http://www.team.net/posting.html
*** unsubscribe/change address requests to [EMAIL PROTECTED] or try
*** http://www.team.net/cgi-bin/majorcool
*** http://www.team.net/mailman/listinfo
*** Archives at http://www.team.net/archive
*** Edit your replies!
