Hello,

If anybody has any experience with those cheaper (e.g. Harbor Freight) stud 
welders,
I'd like to hear about it.  I am starting another project (a '31 Ford) that 
could benefit from one.


Thanks,

Doug Braun
'72 Spit

At 03:20 PM 11/1/2005 -0800, Dan Canaan wrote:
>If I detect body filler on a car, I will make sure I remove it all down to
>bare metal.  The reason is that I don't know what that filler is hiding.
>Was it done as a filler or to cover over a problem?  How thick is it?  Is
>it a problem?
>
>Ideally, you should remove all body filler and see what lay underneath.
>You should then start metalworking to remove as much of the dent/damage as
>possible.  Body filler should only be used for that small amount you can't
>otherwise fix without replacing the panel.  Anything more than 1/4" deep
>is asking for trouble and an indication you need to spend more time on the
>metalwork to bring it closer to the original shape.  Surface weld stud
>guns are ideal for this sort of work to help pull dents out.

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to