You won't know until the bondo's out how big the underlying dent(s)
area is, so do that first.  

Most common along that leading edge of the bonnet is a dent about the
size of a baseball (or golfball if you're lucky).  Pounding it out from
the reverse side is the "correct" way, but sometimes it's either in a
place you can't get to or it simply doesn't seem worth the effort.  

An alternative method is to cut a small oval of sheet metal to go over
the dent (same method as is used when shaving door handles).  When you
weld it in, it will be solid and will require only a thin coat of bondo
to even everything out.

M D "Doc" Nugent
Renton, WA (USA)



--- David Mayer <[EMAIL PROTECTED]> wrote:

> . . .  I also 
> found out that the DPO decided to fill in the whole front end of the
> hood 
> where the letters T-R-I-U-M-P-H are because it had been smashed in,
> Should i 
> attempt to undo that?  or is undoing body filller a no no? . . .
Tired of spam?  Yahoo! Mail has the best spam protection around 

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to