The sole purpose of the regulator is to maintain the proper fuel pressure to the carb(s). So for it to wormk, it must be installed between the pump and the carb(s). If after installing the regulator, you are obtaining much better mileage, my guess is that it is due to the elimination of a loss of fuel fhrough the carb overflow. If the fuel pressure is too high , it will overdrive the float valve and the excess fuel will drain out the overflow pipe, reducing your fuel mileage and causing the smell of raw fuel, if not also causing paint to be removed from the frame where the raw fuel drips down.
Regards, Joe ----- Original Message ----- From: <[EMAIL PROTECTED]> To: "Spitfires" <[email protected]> Sent: Wednesday, July 05, 2006 8:55 AM Subject: updates, schmupdates > It has been a while since i've posted from the land of 10,000 lakes. This summer has been busy and I can't believe it is July already. What happens to the summer when you're an adult now? > > 1. Got the ragtop installed by Dick & Ricks. For $300 they did an amazing, smooth job. They pop-riveted the rear 3 center button snaps, but then again, I was only able to provide 2. It works. A couple concours points off, but I don't mind. Now I can drive it around in the rain. I just gotta get the plastic shells on. > > 2. The fuel conservation saga continues. I bought & installed the Spectre fuel pressure regulator, despite advice not to from previous correspondence on here. > > A 60+ mile round trip, mostly highways seems to have proved that it is helping on fuel economy. While I didn't install it on a full tank(more like 3/4ths full), I'm already at the 140 mile mark, and there's plenty of gas left. Prior to the pressure regulator, it would have been at empty at 140 miles. > > I checked the fuel lines after said round trip, and it was dry as a bone. I'm still not sure of the logic of the instructions saying to install the pressure regulator between the fuel pump & carb, but I did regardless. No fuel leaks. > > The annoying part is I have a minor oil leak where oil is collecting up on the lip of the valve cover! It's gold colored, but I cant' explain how oil is getting "up" on there. Is the valve cover cap bad? It seemed fine when I took it off & examined it. > > Either way, it's driving better with that fuel pressure meter. > > 3. Installed the "speed bleed" screws from NAPA that thankfully fit. This is still an ongoing experiment. I just wish they were a bit longer(like the screws I took out) so I could fit the mityvac hose on it better. Your messages not reaching the list? Check out http://www.team.net/posting.html === This list supported in part by The Vintage Triumph Register === http://www.vtr.org === Help keep Team.Net on the air === http://www.team.net/donate.html === unsubscribe/change address requests to [EMAIL PROTECTED] or try === http://www.team.net/cgi-bin/majorcool === Other lists available at === http://www.team.net/mailman/listinfo === Archives at http://www.team.net/archive === http://www.team.net/the-local === Edit your replies!
