Boy all those little access panels in the ceiling would look real nice.
I don't recall doing a lot of "adjusting or servicing" of grooved fittings after the ceilings went in. Sounds like an architect did that spec. I like the list of specialty tools, we wanted to use an interspatial neutronic laser to verify our grooves. But you had to wait for a lunar eclipse to calibrate it. If not for that one little issue, it would have worked perfect. ;) Just remember these famous words: "Beat to fit and paint to match", makes difficult installations a lot easier. Craig L. Prahl, CET Fire Protection Group Mechanical Department CH2MHILL Lockwood Greene 1500 International Drive PO Box 491, Spartanburg, SC 29304-0491 Direct - 864.599.4102 Fax - 864.599.8439 [EMAIL PROTECTED] http://www.lg.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Fletcher, Ron Sent: Monday, July 30, 2007 4:15 PM To: [email protected] Subject: RE: Corps of Engineers Grv'd Cplg Spec "US Corps of Engineers Albuquerque District Specifications for Bureau of Indian Affairs Kayenta Community School Replacement Navajo County, Arizona" Section 13930A.3.4.7 Pipe Joints: After referencing dial calipers, go/no-go gauges, narrow-land micrometer, NFPA #13 and various other filler material the make grooving of pipe sound difficult the section finishes like this. "Grooved joints shall not be used in concealed locations such as behind walls or ceilings, unless an access panel is shown on the drawings for servicing or adjusting the joint." The RCP's do not show any access panels in the hard lids. I guess we could show the panels on our drawings but then we would probably have to provide them. Thanks for your help. Ron Fletcher Aero Automatic Phoenix, AZ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Thom McMahon Sent: Monday, July 30, 2007 12:49 PM To: [email protected] Subject: Re: Corps of Engineers Grv'd Cplg Spec Ron: Which Gov. spec are you referring to? Thom McMahon Firetech, Inc. 2560 Copper Ridge Dr Steamboat Springs, CO 80488-2136 Tel: 970-879-7952 Fax: 970-879-7926 ----- Original Message ----- From: "Fletcher, Ron" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, July 30, 2007 1:17 PM Subject: Corps of Engineers Grv'd Cplg Spec Anyone out there had any luck getting relief from a COE spec requiring an access panel at every grooved coupling located in concealed locations above hard lids or in walls? Ron Fletcher Aero Automatic Phoenix, AZ _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field)
