Pilot hole is 1/4" with CST Sammys vs larger diam required with a drop in. Andi
-----Original Message----- From: Bob Knight <[email protected]> Sent: Sunday, July 04, 2010 3:04 PM To: [email protected] <[email protected]> Subject: RE: Pre-Cast Concrete Plank Hanger Todd, What sammy? The concrete screw? I looked at that and as long as you hit the in-between points it looks ok. I think you could do the same with inserts, so until something better comes up that's what I'm going with. Happy 4th! Bob -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Todd Williams Sent: Sunday, July 04, 2010 4:59 AM To: [email protected] Subject: Re: Pre-Cast Concrete Plank Hanger There is a Sammy for vertical installation in concrete and their detail shows it going into plank. Would that work? At 08:29 PM 7/3/2010, you wrote: >Hilti has a "shorty" that is usually acceptedn(about 1/4"), other than that >then I guess you have to go with (this has conc tee's?) a sidewinder by >"sammy screws" other than that, basically I've had to do a hanger >(dimensioned) layout and have them installed on the plywood before the pour >and heaven help ya if you forget one. On an off note superglue is being >evaluated by FM. > >On Sat, Jul 3, 2010 at 6:21 PM, Bob Knight <[email protected]> wrote: > > > I'm looking at a project that has pre-cast concrete plank floor and roof > > decks. The spec has specifically disallowed the use of HDI-P inserts. > > What > > other options are available? I've been searching but haven't come up with > > anything else. > > > > Thanks, > > > > Bob Knight > > > > _______________________________________________ > > Sprinklerforum mailing list > > [email protected] > > http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > > > > For Technical Assistance, send an email to: [email protected] > > > > To Unsubscribe, send an email > to:[email protected]<to%3asprinklerforum-requ...@fire sprinkler.org> > > (Put the word unsubscribe in the subject field) > > > > > >-- >Tom Poisal, CET >_______________________________________________ >Sprinklerforum mailing list >[email protected] >http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > >For Technical Assistance, send an email to: [email protected] > >To Unsubscribe, send an email to:[email protected] >(Put the word unsubscribe in the subject field) Todd G. Williams, PE Fire Protection Design/Consulting Stonington, CT 860.535.2080 www.fpdc.com _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
