Perhaps you could start by defining the differences among Group A, B, and C
plastics, along with what configurations of each dictate the current NFPA 13
protection methods.

Bill Brooks

William N. Brooks, P.E.
Brooks Fire Protection Engineering Inc.
372 Wilett Drive
Severna Park, MD 21146-1904
410-544-3620
410-544-3032 FAX
412-400-6528 Cell

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Brad
Casterline
Sent: Monday, February 28, 2011 4:46 PM
To: [email protected]
Subject: RE: re- 'seeing' heat release rate

Steve, ya, I need to let this go (Forum-wise at least), since 13 says
Installation..., not Theory and Installation :). I need to find an SFPE
handbook and spend years trying to figure out what 2+3 is. Still, it would
be nice for something as basic to all of 13 as Heat Release Rate, Quantity,
and Combustibility to have at least a range of numbers attached to the
words, in the annex anyway. Thanks,
Brad

-----Original Message-----
From: Steve Leyton [mailto:[email protected]] 
Sent: Monday, February 28, 2011 2:56 PM
To: [email protected]
Subject: RE: re- 'seeing' heat release rate

Brad:
 
I don't want to open a bucket of worms discussion-wise, but obviously,
what's burning in a "typical" light or ordinary hazard compartment could be
very different within a "uniform" hazard group occupancy.   If my desk and
the mountain of papers scattered across it were to be involved in a fire,
the overall release would be WAY lower than if the sofa in our lobby was
involved.   All light hazard, but our lobby is a much higher potential
energy load.
 
SL

________________________________

From: [email protected] on behalf of Brad Casterline
Sent: Sun 2/27/2011 10:22 AM
To: [email protected]
Subject: re- 'seeing' heat release rate



Experimenters have shown that the Heat of Combustion for a wide range of
combustibles is directly proportional to the amount of O2 consumed= 13,100
Kj/Kg (12,428 BTU/lb).

If so, 1 gallon of water per square foot will handle 7 pounds of fuel per
square foot.

A Christmas tree lot would only be LH if business had been good and this was
Christmas Eve.

Now the Burning Unit is a box weighing 19 pounds~ a 'case'*~~ playing like
beer is an average combustible.

A study of 3 hospitals in 1942 came up with an average fuel load of ~6
pounds per square foot- (an 8-pack).

How hot is a Light Hazard Fire? I have no idea.



*When I dropped out of college a 'case' was 24 beers. According to the
fraternity I TAPPA KEG, a 'case' is now 30 beers. I still use 24.



Ps- At the risk of spinning this until ridiculously twisted, how satisfying
would it be to look for Max Deflector Distance and find-

For Unobstructed Construction= Not TOO far down.

For Obstructed Construction= 1.83 times Unobstructed.

?











 







_______________________________________________
Sprinklerforum mailing list
[email protected]
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum

For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)


_______________________________________________
Sprinklerforum mailing list
[email protected]
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum

For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)

_______________________________________________
Sprinklerforum mailing list
[email protected]
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum

For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)

_______________________________________________
Sprinklerforum mailing list
[email protected]
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum

For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)

Reply via email to