Were the two different areas where they activated subject to a lot of air movement? I ask because Temperature is a measure of the kinetic energy and is statistical, so Ambient is a smeared out type of measurement. Are the heads solder-type?
Brad Casterline -----Original Message----- From: Sprinklerforum [mailto:[email protected]] On Behalf Of Spencer Allen Sent: Wednesday, November 26, 2014 8:20 AM To: [email protected] Subject: RE: Sprinkler Fusible Link Failure I asked the same questions, answer given to us is no. I have also queried if any re-roofing had occurred on the very unlikely scenario the heat may have transferred below. Best Regards, Spencer Allen -----Original Message----- From: Sprinklerforum [mailto:[email protected]] On Behalf Of John Corcoran Sent: 26 November 2014 14:06 To: [email protected] Subject: RE: Sprinkler Fusible Link Failure I know I'm asking the obvious...but was this area subject to higher-than-expected ambient temperatures? Or temperature spikes from some special cause (paint stripping with heat gun etc.)? John Corcoran Globe Fire Sprinkler Corporation 4077 Airpark Drive Standish, MI 48658 Cell: (989) 439-5694 Phone: (989) 846-4583 x 258 Disclaimer: This message contains confidential information and is intended only for the recipient. If you are not the intended recipient, you should not distribute or copy this message. If you have received this message by mistake, please notify us immediately by return e-mail and promptly delete this message and any attachments from your computer system. Globe Fire Sprinkler Corporation and its affiliated companies -----Original Message----- From: Sprinklerforum [mailto:[email protected]] On Behalf Of Spencer Allen Sent: Tuesday, November 25, 2014 2:53 PM To: [email protected] Subject: Sprinkler Fusible Link Failure I have recently had an issue with two CSC type A '1983' sprinklers accidently activating. On inspection of the others following a drain down we found several others without the link in place. We can only assume that this happened once the pressure was removed. Has anyone experience of this happening and reasons why? We can rule out heat, pressure surges and works in the areas. The two heads that activated were in different areas of the system. Best Regards, Spencer Allen _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
