PasTim wrote: > Currently I can't even get squeeze2upnp to work at all with C-3PO so > need to try to set player-specific settings. But they don't work > either. > > Please read the conversation with philippe_44. The way it use > squeezelite inside its bridges require raw pcm streams, that in LMS > means no decoding + upsampling server side. No use for C-3PO (or others) > in this case
PasTim wrote: > > I really don't understand. I have different players with different > needs, so I do not see how I can use the General Settings. In the scenario I figured out from your indications you don't need specific player settings other than supported sample rates and choice to resample or decode. If this is the case, the values in general settings are valid for all the players and you don't need to change them, checking the "use general settings" box is an helper function that means exactly this. Is like to normally have one single address for all the family but name and age for each member. If and when one of them moves to another location, you could specify a new address for him, but all the others still share the same old one. Just aasier than ask you to fill the address for each member. p.s. Considering what philippe_44 explained about his players needs, too bad I think there is actually no way to feed them with a server side upsampled and decoded stream, C-3PO or not. PasTim wrote: > > I did mention two parameters that did not work before, but I'll do so > again. With squeezelite-R2 (still started with -u because I can't use > C-3PO other than to check a few things for you and I don't want to have > to chop and change that setting every time), I proceed as follows. I go > to the player, make sure 'use global' is not ticked. I press > 'show/hide' (I often have to do this twice to see the settings). I > select the Resample box and change the setting to, say ' Always' from > 'Only when samplerate is not supported'. I save. The player settings > disappear so I have to press show/hide again (twice). The settings I > change has not taken effect. The same is true of Quality. I always get > 'High' whatever I change it to. The 'Use Global' is still not ticked > (and in fact the general settings are different from this). Sorry, I did not realize you mentioned those specifically, so "Resample when" and" Quality" are the broken settings. Symptoms are you could change them once, but not anymore, or better, they always come back to the old value after applying. Is that correct? Is not like this in my installation, but I'll have a better look at this. Thanks for your help. I'm aware you sometime have to click twice the button to show/hide parameters, I could not find a reliable solution yet, I'll keep searching. ____________________________________________________________ SB+, Klimo Merlino + Kent Gold, Monitor Audio Studio 20 Gold SE+, Klimo reference and DIS Interconnect. ------------------------------------------------------------------------ marcoc1712's Profile: http://forums.slimdevices.com/member.php?userid=34842 View this thread: http://forums.slimdevices.com/showthread.php?t=105309 _______________________________________________ Squeezecenter mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/squeezecenter
