marcoc1712 wrote: > In the above situation You should get an INFO message at top of the > page: > > > > With the settings you posted, when STDIN is not selected nothing will be > upsampled, since ALL the sample rates are allowed in output, with STDIN > selected instead, everything is upsampled at 192KHz, the max allowed > sample rate.
Hi Marco, thanks for your time and yes I saw the info message and I understand about the stdin. I akso now understand for sure that indeed if input sample rate is same as allowed output sample rate: nothing will happen. BUT it should be possible to upsample to a synchronous EITHER 176400 or 192000 if only these two are checked as output rate. Correct? But as I said: even if I check checkbox in ONLY 176400 and 192000, nothing happens... No sound and no further input on client. Only if I check only 1 of these 2 resampling is done (but the behavior and resulting command are then same as with stdin). To put it short: it looks like the 2 target samples (176400 and 192000) are not properly used as input (although debug log shows these 2 only as true) or the calculation of which one (176400 or 192000) goes wrong? ------------------------------------------------------------------------ Huey11's Profile: http://forums.slimdevices.com/member.php?userid=67632 View this thread: http://forums.slimdevices.com/showthread.php?t=105309 _______________________________________________ Squeezecenter mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/squeezecenter
