Please try to answer the questions below. Regards Henrik
m�n 2003-03-31 klockan 17.25 skrev Tushar Gupta: > Hi, > > The problem of RAM in our configuration remains unsolved. Another thing > we noticed is that swap used as seen by free command always remains > zero. Does it give any clue on what may be the problem. > > We use squid in httpd accelerator mode (interception) > > Thanks for any suggestions > > Tushar > > -----Original Message----- > From: Henrik Nordstrom [mailto:[EMAIL PROTECTED] > Sent: Friday, February 21, 2003 1:35 AM > To: Tushar Gupta; [EMAIL PROTECTED] > Subject: Re: [squid-users] Problem with RAM usage with squid > > Why would you want to do such a thing? > > The "buffer/cache" is automatically returned if applications need more > memory. > > Your problem is elsewhere. You say the idle CPU goes to zero. Which > application is usin all your CPU? (see top). > > And how much memory is reported by free in the "+/- buffers/cache" > row? > > Regards > Henrik > > On Thursday 20 February 2003 15.54, Tushar Gupta wrote: > > Hi, > > > > Is there any mechanism by which I can flush or free up RAM without > > need to reboot the server > > > > Tushar > > > > > > -----Original Message----- > > From: Henrik Nordstrom [mailto:[EMAIL PROTECTED] > > Sent: Tuesday, January 28, 2003 2:53 PM > > To: Tushar Gupta; [EMAIL PROTECTED] > > Subject: Re: [squid-users] Problem with RAM usage with squid > > > > The free ram as reported by top should only be a few MB when a > > server has been in use for a while. What is not used by > > applications should be used by bufffer/cache. > > > > See the output of free for a better reading of "free" ram. > > > > What to watch is the swap usage. On a Squid server the swap usage > > should be low and not increasing. > > > > > > This said, there has been a number of memory leaks in early > > Linux-2.4 kernels. Upgrading to a current 2.4 kernel is most likely > > recommended. > > > > The most commonly hit issue by Squid useds it that the ipchains > > REDIRECT target was utterly broken up to 2.4.18 something. Use the > > native Linux-2.4 iptables command instead. > > > > Regards > > Henrik > > > > On Tuesday 28 January 2003 08.18, Tushar Gupta wrote: > > > Hi, > > > > > > We are using squid for caching, with SCSI disk and 512 MB RAM. > > > The cache_mem setting in squid.conf is 64 MB. After running for > > > several hours total free RAM (as seen by top command) reduces to > > > few kilobytes and server response time increases (CPU idle cycles > > > also go to zero), and we need to reboot the server. Though as > > > percentage of total CPU usage squid is usually taking around > > > 15-30%CPU and percentage of RAM as 12-15%MEM . After rebooting > > > the server would again run fine for several hours say half a day, > > > and then RAM would gradually get consumed again. > > > > > > It is Linux 7.1 , Kernel 2.4.2-2 on i686 (PII 350 Mhz), squid > > > version 2.3.stable4. Server also has other services like > > > DNS/qmail but they take negligible CPU/RAM > > > > > > Any suggestions are welcome. > > > > > > Thanks > > > Tushar -- Henrik Nordstrom <[EMAIL PROTECTED]> MARA Systems AB, Sweden
