Hugh Waite writes:
- Can I do everything I can do in FAILURE_ROUTE in this event route?
No. This event_route uses a new route type (a new BRANCH_FAILURE_ROUTE
flag internally) which means functions and PVs are limited to ones that
have this flag set. So far, I have enabled the functions that are
required to enable outbound flow retries.
Since this route is run in a very similar way to the failure_route, it
is likely that most functions that work in a FAILURE_ROUTE will also
work in a BRANCH_FAILURE_ROUTE just by enabling the flag, but it is a
matter of whether they are appropriate for this route.
hugh,
i tried to enable two new functions on branch failure route by including
the flag:
{"t_branch_timeout", t_branch_timeout, 0, 0,
FAILURE_ROUTE|BRANCH_FAILURE_ROUTE },
{"t_branch_replied", t_branch_replied, 0, 0,
FAILURE_ROUTE|BRANCH_FAILURE_ROUTE },
but i still get to syslog:
0(29943) ERROR: <core> [cfg.y:3412]: misused command t_branch_timeout
0(29943) : <core> [cfg.y:3554]: parse error in config file
/etc/sip-proxy/sip-proxy.cfg, line 2559, column 32: Command cannot be used in
the block
0(29943) ERROR: <core> [cfg.y:3412]: misused command t_branch_replied
0(29943) : <core> [cfg.y:3554]: parse error in config file
/etc/sip-proxy/sip-proxy.cfg, line 2559, column 55: Command cannot be used in
the block
what is it that i still need to do?
-- juha
_______________________________________________
sr-dev mailing list
[email protected]
http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-dev
