Tony,

Once again, thank you for the advice and encouragement. The boiler takes 5 to 6 
minutes to lift the safety with the boiler as full as you describe. Don't know 
the pressure, but I'm using the stock Jane safety that came with the boiler. 
It's operation is typical: first the safety weeps a wift of steam. Then it 
releases more steam (5 minute mark). It will take longer to really lift. 

I have read about Jack Wheldon's pot boiler recommendations. While not an exact 
copy of Jane's, I am using wrappers to confine the flames close aboard the 
boiler. The gap between the wrapper and the firebox side cover is "caulked" 
with a roll of fibreglass cloth to prevent convection currents from passing up 
between the wrapper and firebox side cover. Without the caulking I think that 
the convection currents were interrupting the airflow under the firebox sides 
to the burners. The area above the boiler is now too hot to hold one's hand 
there - when the fire is lit.

I will comply with experimentally fitting a superheater tube through the 
firebox. I'll try it with and without the lubricator in line.

My BAGRS loco has two single-acting wobbler cylinders with the lubricator 
downstream of the superheater, which is nothing more than a 2" run of tubing 
between the wicks in its vertical boiler firebox. That little loco is very 
powerful and steady of speed, so I know what you refer to about your tram loco.

Steve


__________________________________________________________________
Switch to Netscape Internet Service.
As low as $9.95 a month -- Sign up today at http://isp.netscape.com/register

Netscape. Just the Net You Need.

New! Netscape Toolbar for Internet Explorer
Search from anywhere on the Web and block those annoying pop-ups.
Download now at http://channels.netscape.com/ns/search/install.jsp
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to