I always liked the way it looked.....very nice outline. If you've got  
it running well,
you've got something to be proud of.

Ron


On Jan 25, 2006, at 3:11 PM, Gary wrote:

> I agree with Ron that once I fixed all the cut steam lines in the  
> Steamlines
> Shay I resurrected, it lost pressure after about 100' until I made  
> some
> changes. I lapped the valve parts with fine valve grinding compound by
> running the engine on air for a minute slowly then thoroughly  
> cleaning the
> parts and reassembling. I did this twice before escaping steam was  
> almost
> nill from the valves. Next I removed the smoke super heater and  
> simplified
> steam lines to avoid all but the real lubricator. A radiant burner has
> changed this loco into a non stop easy running Shay for up to 34  
> minutes per
> fueling. Of course without a sight glass I have to watch  
> performance to
> ensure water is not running low (ie. Engine speeds up). Lapping the  
> valve on
> plate glass then while assembled greatly reduced spraying steam and  
> steam
> oil. It is still a less efficient motor than most steam engines,  
> but at
> least it runs well. Since my friend has not picked up the engine  
> despite it
> being fixed for four years, perhaps I will proceed with making a  
> new cab.
> The old one was burned off by the "expert" machinist who cut all steam
> lines, and burned the smoke box and bent side frames all in a  
> misguided
> effort to make it work at all. It took me about two days to get the  
> steam
> oil out of the boiler and keep pressure at 2 bar consistently. It  
> was only
> after making a radiant burner that 3-4 bar pressure was consistently
> possible. I like how nicely it runs now.

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to