I agree with Ron that once I fixed all the cut steam lines in the Steamlines
Shay I resurrected, it lost pressure after about 100' until I made some
changes. I lapped the valve parts with fine valve grinding compound by
running the engine on air for a minute slowly then thoroughly cleaning the
parts and reassembling. I did this twice before escaping steam was almost
nill from the valves. Next I removed the smoke super heater and simplified
steam lines to avoid all but the real lubricator. A radiant burner has
changed this loco into a non stop easy running Shay for up to 34 minutes per
fueling. Of course without a sight glass I have to watch performance to
ensure water is not running low (ie. Engine speeds up). Lapping the valve on
plate glass then while assembled greatly reduced spraying steam and steam
oil. It is still a less efficient motor than most steam engines, but at
least it runs well. Since my friend has not picked up the engine despite it
being fixed for four years, perhaps I will proceed with making a new cab.
The old one was burned off by the "expert" machinist who cut all steam
lines, and burned the smoke box and bent side frames all in a misguided
effort to make it work at all. It took me about two days to get the steam
oil out of the boiler and keep pressure at 2 bar consistently. It was only
after making a radiant burner that 3-4 bar pressure was consistently
possible. I like how nicely it runs now.

>> I remember Tom Cooper coming to a steamup in PA with his "Smokey 
>> Shay", and ticking off the host as he sprayed diesel fuel all over 
>> everything within 3 feet in every direction. It ran out of steam 
>> every 10 feet and had to sit there while it built up pressure again.
>> Not a very impressive demonstration.
>>
>> Ron

~ Gary - Steaming over Terror Trestle  
http://community.webshots.com/user/raltzenthor 
http://www.angelfire.com/or/trainguy/ 

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to