Patrick Healy wrote:
>Compressor. What is the best kind for a shop and for
the field/jobsite?
You need to determine what the air demand is for the tools you are using
first.
>What requirements of air supply does
one need for polisher's and hand 'dallet' tools if the
air is turned down to 60 psi as has been suggested?
First of all, A "dallet" air hammer is intended for use on granite and
harder stones. While the tip that Walter Arnold suggested(Down to 60 psi)
works for limestone, you should use 120 psi when using a "dallet". A 1"
"dallet" uses 12 CFM (I had a gauge inserted on my air line and had it
measured) for constant use even though the Trow and Holden catalog specifies
that it uses 6 CFM. Polishing tools use about 15-20 CFM.
- Drills. Anyone have experience with an air powered
rock drill vs. a top of the line electric hammer
drill.
I use both. For any kind of soft or medium hard stone, an electric stone
will suffice. This is not because the electric drill is not powerful enough.
It is because the carbide on the tip of the drill bit is not hard enough for
granite. You can use an electric drill on granite if you are only drilling
an occasional hole. Otherwise an air drill is needed with a drill bit
supplied Trow and Holden is needed. And they use 22 CFM-44 CFM depending on
the drill.
>Opinions of both and should a larger compressor
be purchased to accomodate the additional air supply
requirements of an air drill??
A word about compressors. Unless you are using a rotary screw compressor
which runs constantly, a compressor has a "duty cycle". This means that the
compressor should not be running under a load (pumping up) all the time.
Most compressors work on a 75-80% duty cycle. So if your compressor is
listed as producing 40 CFM then you should use only tools for constant use
that use 30 CFM or less. If you use more you will burn out the motor or pump
or both. If you use your tools on an intermittant basis then you will have
to use your own judgement. Also stay away (if you can afford it) from
compressors that have a RPM at 3000 or higher; they won't last. Most
industrial compressors have a RPM of about 1750.
>Dust control. If we are not in the limestone carving
business and dabble in sandstone and granites dust is a
problem. Any suggestions on dust removal.
If you work inside, you should use a suction system AND a mask. If you work
outside, a mask is sufficient. Suction can cost some money, but silicosis is
far more expensive to deal with.
>Shop Layout. I am sure this is a highly personal and
subjective question, but I am, as an architect, curious
as to how stone sculptor's lay out their shops. Here
in Colorado, there will be the availablility of a nice
outside yard.
A block and tackle attached to an I-beam is the cheapest. I move the heavier
stones around my shop on different carts. I only lift stones above where I
am working and where I am loading.
>This discussion of pneumatics has enlightened me and
sparked my curiousity about acquiring (money budget
permitted) and working stone with pneumatics in a shop
environment.
The best pneumatic tools I have found are Trow and Holden Co. in Barre, VT.
The air hammers are guaranteed for life and their chisels and other tools
stand up to granite.
Seamus O'Mahoney
Montpelier, VT
http://www.sover.net/~omahoney
....................................................................
Learning Stone is hosted free by Spunge.org (http://www.spunge.org).
For list info + help, including subscribe/unsubscribe options,
email message "intro stone" to [EMAIL PROTECTED]