Hi Leo, Actually I would expect that to be the correct behavior after removing the discovery address. iSCSI discover targets are normally used to find the available resources on the target. Once a sucessful logon session is established discovery is out of scope and is not used until a subsequent discovery is initiated or a disconnect occurs. This is the same behavior on other initiators like Microsoft, Cisco, Qlogic and the likes of. However if you were to place authentication requirements into the mix then the removal of the ACL for that initiator should result in a loss of access to the respective target.
Hope that helps. Regards, Mike http://blog.laspina.ca/ -- This message posted from opensolaris.org _______________________________________________ storage-discuss mailing list [email protected] http://mail.opensolaris.org/mailman/listinfo/storage-discuss
