On Jun 12, 2009, at 12:34 PM, Will Murnane <[email protected]>
wrote:
I have an LSI 8308elp card connected to 8 disks, which have two zpools
on them. I want to configure the card so that I can access these
zpools, but I can't figure out how to create volumes without wiping
the disks. I read the manual for MegaCli [1], and it appears that it
may be possible to create single-disk raid 0 arrays through that
interface. However, MegaCli on my machine reports that there are no
adapters installed. How can I make this controller function with ZFS?
Any suggestions for diagnostics I can run or programs I should try
are welcome.
I don't know if MegaCli supports that adapter, if it does, a:
MegaCli -PDList -a0
Will show the physical drives on adapter 0.
Also have you tried raidctl?
-Ross
_______________________________________________
storage-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/storage-discuss
