Hello Dirk! On Tue, Aug 19, 2014 at 4:49 AM, Dirk Hohndel <d...@hohndel.org> wrote:
> - looks very good overall - this will be a wonderful new feature for 4.3 > Thanks - the port detection could be a little smarter; on most platforms you > should be able to TELL which port has an FTDI based device attached and > only those are candidates for being the OSTC3 > I will check on how to include this. Shouldn't be hard. - when saving the backup file the data is saved to the correct file that I > picked in the dialog, but the nice confirmation dialog that is shown > afterwards that "Backup successful" shows the default filename > I will fix it. I had not seen that before. - the widgets showing the gases are a bit unfortunate... the fact that > they each just show a tiny part of the underlying models is > disappointing. Would it be better to add a second tab to the the > information area and have those three widgets there, big enough to show > all gases, dilutents and set points? > > Finally, I haven't looked at the docs, I thought that one could also > change the gradient factors from the PC (that certainly was possible with > the OSTC2). Has that been dropped for the OSTC3 or is this missing in your > UI? > I will move the gas tables to a new tab. About the gradient factors, I am not sure about them, I will have to go through the docs for that. > Thanks > > /D > _______________________________________________ > subsurface mailing list > subsurface@hohndel.org > http://lists.hohndel.org/cgi-bin/mailman/listinfo/subsurface > -- Thanks, Joshua
_______________________________________________ subsurface mailing list subsurface@hohndel.org http://lists.hohndel.org/cgi-bin/mailman/listinfo/subsurface
