On 2014-10-12 16:51, Anton Lundin wrote:
This implements the reading and writing of the configuration varables
from the Suunto Vyper family devices.
Everything here is implemented based on the excellent information on:
http://www.sarnau.info/papers:suunto_vyper
Most of the info on that page is good, but there are also a few areas
where it's a bit outdated. For example some of the model numbers are
wrong, and other models like the D3 and Zoop are missing. You can get
the correct names from libdivecomputer by iterating the device
descriptors.
There is also one model that's an exception to the rule: the Suunto
Spyder uses the vyper protocol, but with a different memory layout. Thus
although your code for changing the settings will work for the Spyder,
you'll most likely be reading/writing to the wrong memory locations. So
that's something to watch out for!
Jef
_______________________________________________
subsurface mailing list
[email protected]
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
