John, > On 13 Sep 2015, at 17:33, John Smith <[email protected] > <mailto:[email protected]>> wrote: > > 2. When you have an initial setpoint of say 0.7 in your plan, there is a > gradient, from surface to the point that air would give you 0.7, in the PPO2 > line, even though that wouldnt be the case in real life on ccr. It also > occurs when you put a set point change in, but that would be likely to have a > gradient.
Sorry, I don’t understand what you want to say here. > 3.If I click toggle ruler, a red line appears on my PPO2 line but I dont know > what it shows (I looked in manual but its not immediately clearof what it > shows). However, if I unclick it it doesn't disappear, that is until I click > on another toggle such as scale graph. Funnily enough, if I don't unclick > toggle ruler and click scale graph, the red line disappears again. > 4.Finally, I ran a buhlmann 100/100 calculation, i would expect the stops to > match up with the tissue limits and calculated ceilings (see attached grab). > They seem to be out of sync in this example. This of course may be because I > don't know what I'm doing :). These seem to be related. In fact, it looks like the planner (but not the displayed ceilings) get the setpoint changes wrong. You can tell by for example changing the stepping of the 50m leg of the dive: That affects the ceilings but not the plan. Will look at this later today. Best Robert
signature.asc
Description: Message signed with OpenPGP using GPGMail
_______________________________________________ subsurface mailing list [email protected] http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
