Your simulation is completely jammed and thus the calibrator cannot insert anything. Or are you targeting mesosim?
Am Do., 24. Feb. 2022 um 15:15 Uhr schrieb Sasan Amini <[email protected]>: > I see. I set the insertionCheck="all" and didn't work. With "none" I can > see more vehicles being inserted visually but haven't checked the outputs > yet. > Here is a small example (so far I have tried on three different networks > and all had the same issue of not inserting vehicles). > > On Thu, Feb 24, 2022 at 2:31 PM Jakob Erdmann <[email protected]> > wrote: > >> insertionCheck is an input attribute. By setting 'insertionCheck="none", >> all insertion attempts succeed and this should be able to achieve the >> desired insertion flow (and lots of collisions). By setting a different >> list of checks you could narrow it down to the check that is most >> influential in preventing insertion (and this would help me in diagnosing >> the problem). >> >> If you can boil it down to a small test case with bad behavior (at >> default insertionChecks), send all inputs to me. >> >> regards, >> Jakob >> >> Am Mi., 23. Feb. 2022 um 18:22 Uhr schrieb Sasan Amini < >> [email protected]>: >> >>> I am not sure if I can find the output of the attribute. I set it and >>> looked at the log and tripinfo but couldn't find anything useful. But the >>> calibrator is indeed inserting some vehicles which I see in both detector >>> output and tripinfo. >>> >>> On Wed, Feb 23, 2022 at 4:28 PM Jakob Erdmann <[email protected]> >>> wrote: >>> >>>> I'd guess that insertion fails for some reason. You could try the new >>>> 'insertionCheck' feature to see which check it runs afoul of. >>>> https://github.com/eclipse/sumo/issues/10114 >>>> >>>> Am Mi., 23. Feb. 2022 um 16:23 Uhr schrieb Sasan Amini < >>>> [email protected]>: >>>> >>>>> Dear all, >>>>> >>>>> I was trying to test the calibrator for a network without any ODs >>>>> following the instructions on: >>>>> https://sumo.dlr.de/docs/Simulation/Calibrator.html. >>>>> I have created an additional file in which I define an edge calibrator >>>>> to increase the flow on that edge to 2500 veh/h (just to make sure I can >>>>> make it work). But it seems that the calibrator doesn't add that many >>>>> vehicles. I can see in the detector output that it adds only 20 vehs. Is >>>>> there something that I am missing? >>>>> >>>>> Thanks for the help. >>>>> Sasan >>>>> >>>>> _______________________________________________ >>>>> sumo-user mailing list >>>>> [email protected] >>>>> To unsubscribe from this list, visit >>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>> >>>> _______________________________________________ >>>> sumo-user mailing list >>>> [email protected] >>>> To unsubscribe from this list, visit >>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To unsubscribe from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
