> if i increase it, the bus will be stuck on the stop. The stopping duration may increase beyond the configured stop 'duration' according to the number of persons entering the bus and the 'boardingDuration' value of the bus. However, unless you've increased the bording duration or the personCapacity of the bus, this should not take too long. You can observed the expected remaining stop duration as explained here: https://sumo.dlr.de/docs/sumo-gui.html#showing_routes_and_route-related_information
Am Mi., 18. Mai 2022 um 10:11 Uhr schrieb Pearla Hajjar < [email protected]>: > Thabk you for your answer. I haven't tried the traci.load yet because I am > trying to solve the problem of stopping. > > For this, when adding a stop, I am assigning the duration. If I put it 1, > the bus will only pick one passenger, if ai increase it, the bus will be > stuck on the stop. > > > > Perla HAJJAR > > Ph.D Student- Universite de Versailles SQ and Communauté d’Agglomération > de Saint Quentin en Yvelines > > Direction des Mobilités- Navettes autonomes > > ------------------------------ > *From:* sumo-user <[email protected]> on behalf of Jakob > Erdmann <[email protected]> > *Sent:* Friday, 13 May 2022, 10:35 > *To:* Sumo project User discussions <[email protected]> > *Subject:* Re: [sumo-user] Assign stops to buses and automatic simulation > launching > > 1. You will have to add each stop of your repeating route individually. > You can use function vehicle.insertStop to add stops anywhere within the > list of existing stops. > > 2. you can use traci.load to relaunch the simulation. (make sure to use > options -S -Q if you're starting sumo-gui). > > Am Fr., 13. Mai 2022 um 10:28 Uhr schrieb Pearla Hajjar < > [email protected]>: > >> Bonjour, >> >> Hope you qre doing good. >> >> I have a question in my project. I am working on assigning different >> stops for buses in each simulation. In the main function I calculate the >> combination of stops the buses should stop at and I want to set then in the >> run funtion where the simulation happens. My questions are: >> >> 1. When i do traci.vehicle.setBusStop it only assigns this stop for the >> bus once in the simulation and I am using a circular root with repeat. How >> can I make the bus stop at these stops at every turn until my stopping >> condition is satisfied? >> >> >> 2. When generating the stopping paattern, I am have different >> combinations. I want to go through each combination and launch the >> simulation automatically after the previous one finishes with the new stop >> pattern. Any idea how to do so? >> >> >> Thank you in advance. >> >> >> Perla HAJJAR >> >> PhD at UVSQ >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
