John Carmichael wrote:
>
> Hi Roger & all:
>
> I agreed with everything Roger said. Translucent stone is bad and 
> shiny stainless steel is bad. I’ve seen that with my own eyes. But my 
> highly polished non-translucent (opaque) beige and brown sandstone 
> dials show a great shadow! So maybe shiny stainless steel has some 
> quality that makes shadows less visible than shiny opaque stone.
>
By coincidence I yesterday completed two long-promised multiple dials 
for BSS members in stainless steel where experience has taught me how to 
deal with these problems. Breaking down its reflectivity is the solution.

1. Mirror-polished SS is useless in dialling because you can't cast a 
shadow on a mirror.

2. 'Satin finish' SS, where all the 'grain' is parallel, is slightly 
better. The best shadows are obtained when looking towards the sun which 
is fine for horizontal dials only. In poor light conditions, or when 
looking 'down sun', a piece of white paper will help to find the shadow.

3. The application of a 'random-orbital' hand sander to even mirror SS 
produces micro 'circles' on the surface giving a very acceptable degree 
of shadow contrast BUT

3.1 The disc *must be in contact* with the surface when the sander is 
switched on to initiate the orbital motion. If this is not done then the 
free-spinning disc will generate BIG circular scratches which are 
difficult to remove later.

3.2 After the whole surface has been sanded satisfactorily in one 
complete operation the disc must be lifted vertically while the machine 
is still running.

I use self-adhesive 120 grit discs for this operation having first 
'killed' the initial coarseness on a piece of scrap material. This gets 
ride of any oversize grit making deeper scratches.

Random-orbital sanders are used in car body shops for leveling and 
contouring filler pastes and my own is an industrial version bought for 
prolonged use in my aircraft work. I have seen cheaper versions in DIY 
stores but have no experience of how well they would do this work.

The two dials referred to earlier may be on display at the forthcoming 
BSS Conference.

JPEG of the sander in use on request.

Tony Moss.

P.S. For three large stainless steel dials in the London area, where I 
was responsible for the majority of the design work and specifications, 
I recommended 'bead blasting' of stainless steel. This process, where a 
high-pressure stream of tiny glass beads produces a 'velvety' surface, 
is ideal for dialling work in many ways.

Sand blasting also works well but the micro sharp-edged cavities 
produced by sand particles may retain dirt.
---------------------------------------------------
https://lists.uni-koeln.de/mailman/listinfo/sundial

Reply via email to